Slip Over Double Winter Wrap

Limited quantities available to pre-order. ETA into Calgary second week of October.

This wrap covers 2 colonies placed side-by-side.

Looking to wrap just one hive? Check out the Single Slip Over Wrap HERE

BEE HIVE WINTERING COVER FITTED KIT DOUBLE 2 STOREY

INSTRUCTIONS
STEP 1 – Place 2 hives x 2 story with (inner) lids beside each other on pallet
STEP 2 – Place side wrap with attached cover over set of 2 hives
STEP 3 – Align silver grommet holes in cover with upper hive entrances
STEP 4 – Using screw and washer supplied place fasten directly below grommets in center and into hive frame so the grommets are held tightly in position over the upper hive entrances.
STEP 5 – Place supplied pillow on top of hive lids.
STEP 6 – Close top & fasten using supplied rubber rope and hooks. The rubber rope fastening at the rear of the lid should cross over from top corner to opposite bottom corner. The fastening at the outer grommets at the front of the lids should angle towards the center. The middle 2 grommets at the center of the lid should fasten straight down. This will create a tented area over the entrances to allow access.

Parts –
1 R8 Side & top cover 1 R20 insulating pillow
12 feet 3/8 rubber rope 6 rubber rope hooks
2 #8 X 1” Robertson screws & washers.